我々は販売者とお客様の間の信頼が重要でもらい難いのを知っています。我々はCiscoの200-301模擬解説集ソフトであなたに専門と高効率を示して、最全面的な問題集と詳しい分析であなたに助けてCiscoの200-301模擬解説集試験に合格して、最高のサービスであなたの信頼を得ています。あなたが試験に合格するのは我々への一番よい評価です。 Omgzlookは多くの受験生を助けて彼らにCiscoの200-301模擬解説集試験に合格させることができるのは我々専門的なチームがCiscoの200-301模擬解説集試験を研究して解答を詳しく分析しますから。試験が更新されているうちに、我々はCiscoの200-301模擬解説集試験の資料を更新し続けています。 その中の一部は暇な時間だけでCiscoの200-301模擬解説集試験を準備します。
CCNA 200-301 暇の時間を利用して勉強します。
我々200-301 - Cisco Certified Network Associate Exam模擬解説集問題集を利用し、試験に参加しましょう。 そして、200-301 的中問題集試験参考書の問題は本当の試験問題とだいたい同じことであるとわかります。200-301 的中問題集試験参考書があれば,ほかの試験参考書を勉強する必要がないです。
あなたはまだ躊躇しているなら、Omgzlookの200-301模擬解説集問題集デモを参考しましょ。なにごとによらず初手は难しいです、どのようにCisco 200-301模擬解説集試験への復習を始めて悩んでいますか。我々のCisco 200-301模擬解説集問題集を購買するのはあなたの試験に準備する第一歩です。
Cisco 200-301模擬解説集問題集はIT専門家が長年の研究したことです。
きみはCiscoの200-301模擬解説集認定テストに合格するためにたくさんのルートを選択肢があります。Omgzlookは君のために良い訓練ツールを提供し、君のCisco認証試に高品質の参考資料を提供しいたします。あなたの全部な需要を満たすためにいつも頑張ります。
私たちの200-301模擬解説集試験参考書を利用し、200-301模擬解説集試験に合格できます。おそらくあなたは私たちの200-301模擬解説集試験参考書を信じられないでしょう。
200-301 PDF DEMO:
QUESTION NO: 1
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
QUESTION NO: 2
Which network allows devices to communicate without the need to access the Internet?
A. 209.165.201.0/24
B. 192.0.0.0/8
C. 172.28.0.0/16
D. 1729.0.0/16
Answer: C
Explanation:
This question asks about the private ranges of IPv4 addresses. The private ranges of each class of IPv4 are listed below:
Class A private IP address ranges from 10.0.0.0 to 10.255.255.255 Class B private IP address ranges from 172.16.0.0 to 172.31.255.255 Class C private IP address ranges from 192.168.0.0 to
192.168.255.255 Only the network 172.28.0.0/16 belongs to the private IP address (of class B).
QUESTION NO: 3
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 4
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 5
Which set of action satisfy the requirement for multi-factor authentication?
A. The user enters a user name and password and then re-enters the credentials on a second screen
B. The user swipes a key fob, then clicks through an email link
C. The user enters a user name and password, and then clicks a notification in an authentication app on a mobile device
D. The user enters a PIN into an RSA token, and then enters the displayed RSA key on a login screen
Answer: C
Explanation:
This is an example of how two-factor authentication (2FA) works:
1. The user logs in to the website or service with their username and password.
2. The password is validated by an authentication server and, if correct, the user becomes eligible for the second factor.
3. The authentication server sends a unique code to the user's second-factor method (such as a smartphone app).
4. The user confirms their identity by providing the additional authentication for their second-factor method.
Omgzlookの専門家チームがCiscoのMicrosoft DP-700認証試験に対して最新の短期有効なトレーニングプログラムを研究しました。 Juniper JN0-683 - 安心に弊社の商品を選ぶとともに貴重な時間とエネルギーを節約することができる。 Salesforce Advanced-Administrator-JPN - きっと君に失望させないと信じています。 Oracle 1z0-1066-24 - しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。 Salesforce DEX-450 - 我々は受験生の皆様により高いスピードを持っているかつ効率的なサービスを提供することにずっと力を尽くしていますから、あなたが貴重な時間を節約することに助けを差し上げます。
Updated: May 28, 2022