200-301最新な問題集 & Cisco Certified Network Associate Exam対応問題集 - Omgzlook

すべてのことの目的はあなたに安心に試験に準備さされるということです。弊社のOmgzlookはIT認定試験のソフトの一番信頼たるバンドになるという目標を達成するために、弊社はあなたに最新版のCiscoの200-301最新な問題集試験問題集を提供いたします。弊社のソフトを使用して、ほとんどのお客様は難しいと思われているCiscoの200-301最新な問題集試験に順調に剛角しました。 多くのサイトの中で、どこかのCiscoの200-301最新な問題集試験問題集は最も正確性が高いですか。無論OmgzlookのCiscoの200-301最新な問題集問題集が一番頼りになります。 試験に失敗したら、全額で返金する承諾があります。

CCNA 200-301 できるだけ100%の通過率を保証使用にしています。

だから、弊社の提供する200-301 - Cisco Certified Network Associate Exam最新な問題集問題集を暗記すれば、きっと試験に合格できます。 Ciscoの200-301 教育資料試験のソフトは問題数が豊富であなたに大量の練習で能力を高めさせます。そのほかに、専門家たちの解答への詳しい分析があります。

Omgzlookは同業の中でそんなに良い地位を取るの原因は弊社のかなり正確な試験の練習問題と解答そえに迅速の更新で、このようにとても良い成績がとられています。そして、弊社が提供した問題集を安心で使用して、試験を安心で受けて、君のCisco 200-301最新な問題集認証試験の100%の合格率を保証しますす。OmgzlookにたくさんのIT専門人士がいって、弊社の問題集に社会のITエリートが認定されて、弊社の問題集は試験の大幅カーバして、合格率が100%にまで達します。

Cisco 200-301最新な問題集 - 弊社の量豊かの備考資料はあなたを驚かさせます。

どんな業界で自分に良い昇進機会があると希望する職人がとても多いと思って、IT業界にも例外ではありません。ITの専門者はCiscoの200-301最新な問題集認定試験があなたの願望を助けって実現できるのがよく分かります。Omgzlookはあなたの夢に実現させるサイトでございます。

我々社のCisco 200-301最新な問題集問題集とサーブすが多くの人々に認められます。最近、Cisco 200-301最新な問題集問題集は通過率が高いなので大人気になります。

200-301 PDF DEMO:

QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html

QUESTION NO: 2
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html

QUESTION NO: 3
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.

QUESTION NO: 4
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html

QUESTION NO: 5
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/

EMC D-PE-OE-23 - 一目でわかる最新の出題傾向でわかりやすい解説と充実の補充問題があります。 なぜ彼らがSalesforce CRT-261J問題集を選ぶかというと、弊社のSalesforce CRT-261J問題集は高品質で、便利で、勉強しやすいからです。 Amazon SCS-C02-KR - あなたに向いていることを確かめてから買うのも遅くないですよ。 できるだけ早くCisco Microsoft MS-102認定試験「Cisco Certified Network Associate Exam」を通ろう。 CiscoのFortinet FCSS_NST_SE-7.4認定試験に受かるのはあなたの技能を検証することだけでなく、あなたの専門知識を証明できて、上司は無駄にあなたを雇うことはしないことの証明書です。

Updated: May 28, 2022