調査、研究を経って、IT職員の月給の増加とジョブのプロモーションはCisco 200-301復習問題集資格認定と密接な関係があります。給料の増加とジョブのプロモーションを真になるために、OmgzlookのCisco 200-301復習問題集問題集を勉強しましょう。いつまでも200-301復習問題集試験に準備する皆様に便宜を与えるOmgzlookは、高品質の試験資料と行き届いたサービスを提供します。 OmgzlookのCiscoの200-301復習問題集の試験問題は同じシラバスに従って、実際のCiscoの200-301復習問題集認証試験にも従っています。弊社はずっとトレーニング資料をアップグレードしていますから、提供して差し上げた製品は一年間の無料更新サービスの景品があります。 この目標の達成はあなたがIT技術領域へ行く更なる発展の一歩ですけど、我々社Omgzlook存在するこそすべての意義です。
CCNA 200-301 我々の誠意を信じてください。
OmgzlookにCiscoの200-301 - Cisco Certified Network Associate Exam復習問題集試験のフルバージョンがありますから、最新のCiscoの200-301 - Cisco Certified Network Associate Exam復習問題集のトレーニング資料をあちこち探す必要がないです。 自分のIT業界での発展を希望したら、Ciscoの200-301 合格体験記試験に合格する必要があります。Ciscoの200-301 合格体験記試験はいくつ難しくても文句を言わないで、我々Omgzlookの提供する資料を通して、あなたはCiscoの200-301 合格体験記試験に合格することができます。
Ciscoの200-301復習問題集試験と言ったら、Omgzlook のCiscoの200-301復習問題集試験トレーニング資料はずっとほかのサイトを先んじているのは、Omgzlook にはIT領域のエリートが組み立てられた強い団体がありますから。その団体はいつでも最新のCisco 200-301復習問題集試験トレーニング資料を追跡していて、彼らのプロな心を持って、ずっと試験トレーニング資料の研究に力を尽くしています。Ciscoの200-301復習問題集認定試験は業界で広く認証されたIT認定です。
Cisco 200-301復習問題集 - 成功の喜びは大きいです。
人生にはあまりにも多くの変化および未知の誘惑がありますから、まだ若いときに自分自身のために強固な基盤を築くべきです。あなた準備しましたか。OmgzlookのCiscoの200-301復習問題集試験トレーニング資料は最高のトレーニング資料です。IT職員としてのあなたは切迫感を感じましたか。Omgzlookを選んだら、成功への扉を開きます。頑張ってください。
ほかのたくさんの受験生は生活の中でのことに挑戦しています。だから、我々は受験生の皆さんに一番効果的なCiscoの200-301復習問題集復習方法を提供します。
200-301 PDF DEMO:
QUESTION NO: 1
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 2
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 3
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
QUESTION NO: 4
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 5
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
Pegasystems PEGAPCDC87V1 - IT技術の急速な発展につれて、IT認証試験の問題は常に変更されています。 EMC D-MSS-DS-23 - 自分の幸せは自分で作るものだと思われます。 あるいは、無料で試験Salesforce Nonprofit-Cloud-Consultant問題集を更新してあげるのを選択することもできます。 もしあなたはCiscoのHP HPE0-V27試験に準備しているなら、弊社OmgzlookのHP HPE0-V27問題集を使ってください。 Microsoft DP-300-KR - なぜ受験生のほとんどはOmgzlookを選んだのですか。
Updated: May 28, 2022