Omgzlookを利用するのは君の合格率を１００％保証いたします。Omgzlookは多種なIT認証試験を受ける方を正確な資料を提供者でございます。弊社の無料なサンプルを遠慮なくダウンロードしてください。 だから、弊社の提供する200-301学習体験談問題集を暗記すれば、きっと試験に合格できます。数年以来の整理と分析によって開発された200-301学習体験談問題集は権威的で全面的です。 Omgzlook のCiscoの200-301学習体験談問題集はあなたが楽に試験に受かることを助けます。
それはOmgzlookの200-301学習体験談問題集です。
CCNA 200-301学習体験談 - Cisco Certified Network Associate Exam あなたはOmgzlookの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。 Omgzlookは君にとってベストな選択になります。ここには、私たちは君の需要に応じます。
購入した前にCiscoの200-301学習体験談ソフトのような商品の適用性をあなたに感じさせるために、我々はCiscoの200-301学習体験談ソフトのデモを提供して、あなたはOmgzlookで無料でダウンロードして体験できます。何か疑問があれば、我々の係員を問い合わせたり、メールで我々を連絡したりすることができます。あなたは弊社を選ぶとき、Ciscoの200-301学習体験談試験に合格する最高の方法を選びます。
Cisco 200-301学習体験談 - 正しい方法は大切です。
Omgzlookの200-301学習体験談問題集はあなたを楽に試験の準備をやらせます。それに、もし最初で試験を受ける場合、試験のソフトウェアのバージョンを使用することができます。これは完全に実際の試験雰囲気とフォーマットをシミュレートするソフトウェアですから。このソフトで、あなたは事前に実際の試験を感じることができます。そうすれば、実際の200-301学習体験談試験を受けるときに緊張をすることはないです。ですから、心のリラックスした状態で試験に出る問題を対応することができ、あなたの正常なレベルをプレイすることもできます。
試験が更新されているうちに、我々はCiscoの200-301学習体験談試験の資料を更新し続けています。できるだけ100％の通過率を保証使用にしています。
200-301 PDF DEMO:
QUESTION NO: 1
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
QUESTION NO: 2
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 3
Refer to the exhibit. After you apply the given configuration to arouter, the DHCP clients behind the device connot communicate with hosts outside of their subnet.
Which action is most likely to correct the problem?
A. configure the default gateway
B. Configure the dns server on the same subnet as the clients
C. Activate the dhcp pool
D. Correct the subnet mask
Answer: A
QUESTION NO: 4
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 5
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
ISACA IT-Risk-Fundamentals - Omgzlookの問題集を利用してから、試験を受けるときに簡単に対処し、楽に高い点数を取ることができます。 Cisco 200-201J - 自分の幸せは自分で作るものだと思われます。 Google Professional-Cloud-Network-Engineer - この認定は君のもっと輝い職業生涯と未来に大変役に立ちます。 あなたは弊社の高品質Cisco Microsoft MS-900-KR試験資料を利用して、一回に試験に合格します。 OmgzlookのCiscoのHP HP2-I73問題集を購入するなら、君がCiscoのHP HP2-I73認定試験に合格する率は１００パーセントです。
Updated: May 28, 2022