200-301問題と解答 & Cisco Certified Network Associate Exam最新資料 - Omgzlook

Omgzlookの専門家チームが君の需要を満たすために自分の経験と知識を利用してCiscoの200-301問題と解答認定試験対策模擬テスト問題集が研究しました。模擬テスト問題集と真実の試験問題がよく似ています。一目でわかる最新の出題傾向でわかりやすい解説と充実の補充問題があります。 Ciscoの200-301問題と解答の認証試験について、あなたは異なるサイトや書籍で色々な問題を見つけることができます。しかし、ロジックが接続されているかどうかはキーです。 あなたはいつでもサブスクリプションの期間を延長することができますから、より多くの時間を取って充分に試験を準備できます。

CCNA 200-301 ここには、私たちは君の需要に応じます。

CCNA 200-301問題と解答 - Cisco Certified Network Associate Exam この参考書は短い時間で試験に十分に準備させ、そして楽に試験に合格させます。 OmgzlookのCiscoの200-301 テスト問題集試験トレーニング資料は試験問題と解答を含まれて、豊富な経験を持っているIT業種の専門家が長年の研究を通じて作成したものです。その権威性は言うまでもありません。

Ciscoの200-301問題と解答認証資格を取得すると、あなたは大きなヘルプを得ることができます。では、どのようにはやく試験に合格するかを知りたいですか。Omgzlookの200-301問題と解答参考資料はあなたの目標を達成するのに役立ちます。

Cisco 200-301問題と解答 - それをもって、試験は問題になりませんよ。

Omgzlookの200-301問題と解答問題集は多くの受験生に検証されたものですから、高い成功率を保証できます。もしこの問題集を利用してからやはり試験に不合格になってしまえば、Omgzlookは全額で返金することができます。あるいは、無料で試験200-301問題と解答問題集を更新してあげるのを選択することもできます。こんな保障がありますから、心配する必要は全然ないですよ。

Omgzlookはとても人気がありますから、それを選ばない理由はないです。もちろん、完璧なトレーニング資料を差し上げましたが、もしあなたに向いていないのなら無用になりますから、Omgzlookを利用する前に、一部の問題と解答を無料にダウンロードしてみることができます。

200-301 PDF DEMO:

QUESTION NO: 1
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html

QUESTION NO: 2
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html

QUESTION NO: 3
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html

QUESTION NO: 4
Refer to the exhibit. After you apply the given configuration to arouter, the DHCP clients behind the device connot communicate with hosts outside of their subnet.
Which action is most likely to correct the problem?
A. configure the default gateway
B. Configure the dns server on the same subnet as the clients
C. Activate the dhcp pool
D. Correct the subnet mask
Answer: A

QUESTION NO: 5
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.

OmgzlookのITエリートたちは彼らの専門的な目で、最新的なCiscoのACAMS CAMS-JP試験トレーニング資料に注目していて、うちのCiscoのACAMS CAMS-JP問題集の高い正確性を保証するのです。 IAPP CIPT - それはOmgzlookが提供する問題資料は絶対あなたが試験に受かることを助けられるからです。 CiscoのHP HPE0-V27-KR認定試験に合格することはきっと君の職業生涯の輝い将来に大変役に立ちます。 Omgzlook CiscoのCisco 300-510試験問題集はあなたが自分の目標を達成することを助けられます。 我々Omgzlookは一番効果的な方法を探してあなたにCiscoのJuniper JN0-214試験に合格させます。

Updated: May 28, 2022