自分がやっていることに満足していますか。自分のレベルを高めたいですか。では、仕事に役に立つスキルをもっと身に付けましょう。 すべては豊富な内容があって各自のメリットを持っています。あなたは各バーションのCiscoの200-301ソフトウエア試験の資料をダウンロードしてみることができ、あなたに一番ふさわしいバーションを見つけることができます。 実際にはそれは全く不要です。
はやくOmgzlookの200-301ソフトウエア問題集を入手しましょう。
競争力が激しい社会に当たり、我々Omgzlookは多くの受験生の中で大人気があるのは受験生の立場からCisco 200-301 - Cisco Certified Network Associate Examソフトウエア試験資料をリリースすることです。 OmgzlookのCiscoの200-301 トレーニング資料の試験問題と解答は当面の市場で最も徹底的な正確的な最新的な模擬テストです。煩わしいCiscoの200-301 トレーニング資料試験問題で、悩んでいますか？悩むことはありません。
だから、弊社の提供する200-301ソフトウエア問題集を暗記すれば、きっと試験に合格できます。数年以来の整理と分析によって開発された200-301ソフトウエア問題集は権威的で全面的です。200-301ソフトウエア問題集を利用して試験に合格できます。
CiscoのCisco 200-301ソフトウエア試験への復習に悩んでいますか。
どんな業界で自分に良い昇進機会があると希望する職人がとても多いと思って、IT業界にも例外ではありません。ITの専門者はCiscoの200-301ソフトウエア認定試験があなたの願望を助けって実現できるのがよく分かります。Omgzlookはあなたの夢に実現させるサイトでございます。
我々のCiscoの200-301ソフトウエアソフトはあなたのすべての需要を満たすのを希望します。問題集の全面性と権威性、Ciscoの200-301ソフトウエアソフトがPDF版、オンライン版とソフト版があるという資料のバーションの多様性、購入の前にデモの無料ダウンロード、購入の後でCiscoの200-301ソフトウエアソフトの一年間の無料更新、これ全部は我々の誠の心を示しています。
200-301 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 2
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 3
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
QUESTION NO: 4
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 5
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
SAP C-ABAPD-2309 - 模擬テスト問題集と真実の試験問題がよく似ています。 CompTIA N10-008J - あなたはその中の一員になりたいですか。 OmgzlookのCiscoのSAP C-ABAPD-2309の試験問題は同じシラバスに従って、実際のCiscoのSAP C-ABAPD-2309認証試験にも従っています。 初心者といい、数年IT仕事を従事した人といい、我々OmgzlookのCisco Salesforce Industries-CPQ-Developer問題集は最良の選択であると考えられます。 CiscoのMicrosoft MB-910認定試験に受かるのはあなたの技能を検証することだけでなく、あなたの専門知識を証明できて、上司は無駄にあなたを雇うことはしないことの証明書です。
Updated: May 28, 2022